These are the ECUs the NefMoto ECU flashing software has been tested and is supported on. It will display all of the info about the FTDI chip in the cable and say if it supports premium NefMoto features. Just select the USB device and then hover your mouse over it. If you want to check what chip is in your cable, or see if it supports NefMoto premium features, you can use the NefMoto ECU Flasher version 1.6.1.0 or later.
If you have a generic cable, download CDM20600.zip from the same forum post you got the MSI, then extract it and install the generic FTDI D2XX driver.Ensure that you have the FTD2XX driver installed for your specific cable.Run the MSI installer downloaded from the NefMoto forum.Uninstall any previous versions of the NefMoto software before installing the latest version, just to be safe.
The latest release can be found here: NefMoto ME7 Flasher Logger How to install The Nefmoto ECU flashing software is free to download and use. Please let Tony know via forum PM or email if you find any more issues. You can then restore it (in boot mode) in the event of a problem. If you have one of these aftrmarket tunes, backup your EEprom using ArgDub's tool.
The only official way to clear this error code is to write a new flash file to your ECU. Verifying the memory layout on ECUs with these tunes appears to cause a "Programming not finished" error code.
Does not update checksums or validate the file you are flashing in any way.Reading and clearing error codes is also supported.Written and read data is verified with checksums to ensure data was sent correctly.
Dumb mode cables pass the raw serial data straight through without applying any higher level protocols. All that is required is a FTDI based USB OBD cable that works in "dumb" mode.
The NefMoto ME7 ECU flasher is a free tool that allows you to read and write the flash memory in your ME7 ECU in car over the OBD port.